Most people who are not from the Pacific Northwest have no idea how beautiful our summers are. Summer in Western Washington is in a word: ideal. The temperature ranges from the seventies to mid-eighties, the humidity is very low, everything is lush and green, and the mosquitoes are few. This is why we chose to have an outdoor summer wedding – because we know how gorgeous it will be, and we want to share that especially with our out-of-state friends & family (local folks already know how good they have it, haha).
This means getting my parents’ yard to idyllic condition will be key. Slowly but surely we are planning our course of action. Not many things can be done far in advance, but I’m tackling the little things that can.
One small detail is a wrought iron bench, which sits under some shady boughs at one end of the property. I want to make that spot inviting. I had found a very cool length of upholstery fabric at a thrift store that I didn’t know what to do with, and my mom suggested a comfy bench cushion. Genius!
This project took very little time and was also very cost effective. Here’s what I did:
First, measuring is important. The benchseat measured 48″ long by 18″ deep. And I wanted a thick comfy cushion, so I decided 2″ thick would be good.
To get the fabric cut to the correct lengths for this end result, I would have two panels of fabric measuring 51″x21″
(Take your length and add 1.5″ to each side – the .5″ is for seam allowance)
Next, pin your 2 panels together, good sides facing each other, and sew all the way around, leaving about a 6″ opening so later you can turn it inside out and stuff it.
Once you’ve sewn the perimeter, put your hand inside the corner and lay it flat – this is how we get square corners. Here’s a little diagram I whipped up:
Here’s what your square corner will look like:
Once all four corners have been squared off, turn the case right-side-out, and you are ready to stuff it! ^_^
When your cushion has been filled (I used about 52 oz of poly-fil) the opening needs to be sewn closed. I just did this by hand – pinned the two layers together and then stitched with a needle and thread.
So at this point, I had a big mound of a cushion, so to tame it, I sewed three buttons to pinch the pillow down.
And the buttons just happened to be 3 of my own design and crafting, so it’s extra special 🙂 You can check out more of my ceramic buttons at my Jadeflower shop!
So there you have it! I can’t wait to bring my finished cushion home and try it out on that bench. Oh my mama will be so proud 😛 haha
Maybe some coordinating throw pillows are in order, too!